The Repti Flo 200 Circulation Pump has an energy-efficient and maintenance-free motor that provides a powerful continuous output flow. Perfect for improving water oxygenation; providing water circulation in aqua-terrariums and paludariums; or powering terrarium streams and waterfalls. This compact pump is fully submersible. The Repti Flo 200 Circulation Pump can also be used as a replacement pump for all sizes of the Exo Terra Waterfalls.

• Multi-purpose, submersible pump for aqua-terrariums and paludariums
• Replacement pump for Exo Terra Waterfall
• Energy-efficient, maintenance-free motor
• For indoor and submersible use only
• 110 Volts
• Takes 3/16" ID tubing (inner diameter)

• For INDOOR, FRESHWATER use only
• Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.
• If the pump shows any sign of abnormal water leakage, immediately unplug it from the power source.
• Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is dropped or damaged in any manner. The power cord of this appliance cannot be replaced; if the cord is damaged, the appliance should be discarded. Never cut the cord.
• To avoid the possibility of the appliance plug or electrical socket getting wet, position the unit to one side of a wall mounted socket to prevent water from dripping onto the socket or plug. A “drip-loop” should be arranged. The “driploop” is that part of the cord below the level of the socket, or the connector if an extension cord is used, to prevent water from traveling along the cord and coming into contact with the socket. If the plug or socket does get wet, DO NOT unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the appliance. Then unplug and examine for the presence of water in the socket.
• It is suggested that this appliance be equipped with a leakage circuit breaker. Warning: For North American market only. To prevent electric shock, supply electrical power through a wall mounted Residual Current Device (GFI-Ground Fault Current Interrupter) with a residual operating current not exceeding 30mA. If the appliance shows any sight of current leakage or if the GFI switches off, disconnect the power supply from mains and remove the appliance from the water
• Always unplug an appliance from an outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank cord to pull the plug from the outlet. Grasp the plug and pull to disconnect.
• Disconnect the plug of this and any other submersed appliance before placing hands in the water.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled. 8. Read and observe all the important notices on the appliance.
• Do not install or store the appliance where it will be exposed to the weather or to temperatures below freezing. 11. Do not expose the appliance under sunlight or place at low temperature for a long period of time.
• The pump must be immersed in water. The pump must not run dry.
• GROUNDING INSTRUCTIONS (for USA only): This appliance should be grounded to minimize the possibility of electric shock. This appliance is equipped with an electric cord having an equipment grounding conductor and a grounded type plug. The plug must be plugged into an outlet that is installed and grounded in accordance with all appropriate codes and ordinances

If you need more information check out the Information Manual

THIS PRODUCT CANNOT BE SHIPPED OUTSIDE OF THE UNITED STATES. Due to distribution contracts Hagen has with its distributors around the world, we cannot ship their brands (AquaClear, Exo Terra, Fluval, Marina, and Nutrafin) outside of the United States. Our apologies for any inconvenience!